How To Install Bathroom Faucet Drain
Loosen and remove the p trap from the branch drain and sink drain tailpiece using.
How to install bathroom faucet drain. Start by attaching the hoses to the faucet first. From beneath the sink tighten the mounting nuts to keep the faucet in place. Fasten the nuts snug but do not over tighten.
Normally this will mean. Apply a thin layer of. Installing a faucet and drain.
Believe it or not but you do not need to be an expert on plumbing to learn how to install a bathroom faucet with pop up drain. Prepare the new pop up drain stopper. From the underside of the sink add the rubber gasket and metal locking nut to the drain.
Learn how to replace it. Disassemble the pieces of the new pop up assembly and unscrew and remove the. Push the drain body down into the sink until silicone oozes out from the connection.
Use a basin wrench or a sink installer tool being careful to not over tighten the nuts. Clean this excess silicone from the sink and drain. Disconnect the water supply tubes.
Does your sink have a pop up drain. Begin by shutting off the hot and cold water supply to the sink. In this episode of repair and replace stephany shows how to replace a drain in a bathroom sink.
Attach the water supply hoses. Once the waste drain is cut slide on a slip joint nut facing towards yourself then another nut facing the wall and lastly the remaining washer tapered side towards the wall. Connect the faucet connect flexible water supply lines from the connection on the water shut off valves to the end of the faucet supply lines by applying plumber s tape to the threaded ends of the faucet supply line and attaching the water supply lines and nuts to the faucet supply lines.
Apply clear silicone to the underside of the drain collar. Shut off the water. Wipe away any excess putty from around the faucet base.
Your pipe may be too long and can be cut using a hacksaw. Now attach the two hoses to the water supply valves in the wall under the sink. Home improvement step 1.
Insert the pipe into the wall and screw it onto the adapter. Apply pipe joint compound. Instructions remove the old drain assembly.
The pop up drain is definitely the preferred drain type for most of us when it comes to our bathroom faucet. Gathering a few simple materials together you can complete the project in hardly any time at all. Next connect the waste drain to the wall.
Disconnect the flexible water supply tubes that run from the shutoff valves. Our solution is to apply 100 silicone sealant to the underside of the drain and to the sink. To finish tightening the nuts use the basin wrench to turn each nut a quarter turn to the right clockwise.
Attach each hose to the tailpipe of the faucet and then tighten the nut by hand.
